Signal NVR2716 Manual de usuario descargar pdf (Pagina 14)

- 14 -

Pic 2.5.5.2 PTZ control

2、

、、

、Tour

Multiple preset points connected tour ,the PTZ run around on the line

1）Tour Settings

Tour is connected by multiple preset points, setting procedure is as follows:

Step1: In Picture 2.5.5.0, the Direction key will turn PTZ to designated location ,click Settings

button to enter Picture 2.5.5.3.

Step 2: click Tour buttons, then input proper value into the Preset points and Patrol No blank，

click Add Preset Points button, complete setting (also can add and delete tour preset which has been set

up)

Step 3: repeat step1 and step2 , until set out all the preset designated Cruise lines.

Remove Preset：Please input preset value in the blank, click Remove Preset button, then

remove the preset points.

Remove Tour：Input the number of tour, click Remove tour button, then remove the tour set。

Pic 2.5.5.3 Tour setup

2）The Calls of Tour

In Picture 2.5.5.0, click Page Switch button, enter PTZ control menu as shown in Picture 2.5.5.2.

Please input the number of tour in the value blank, then click tour button, PTZ begins to work on the tour

patrol. Click Stop button to stop tour.

Value input blank

Tour Button

Patrol number Blank

Preset Points Blank

Time interval

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 50 51

Sin comentarios

Signal NVR2716 Manual de usuario Pagina 14