Signal NVR 2708 Especificaciones descargar pdf (Pagina 10)

２-５

Terminal Block

The terminal blocks in the rear of the product are for the connection of PTZ / Sensor / Relay / POS Connection.

The number of the terminal block may be different depending on the model.

① PTZ Camera/Keyboard Controller

Connect PTZ control cable; TRX+, TRX- and GND to Terminal Block(TB1);No.4 TRXD+, No.5 TRXD- and No.10

GND in the rear of NVR. You may refer to APPENDIX for supported PTZ cameras in this manual. Keyboard

controller has the same connection as PTZ camera.

② Sensor / Relay / POS

Connect Sensor / Relay / POS to the terminal block directly depending on the model.

Sensor and Relay Type

NC(Normal Close) : Normally closed; opens when a signal is received

NO(Normal Open) : Normally open; closes when a signal is received

The external alarm device may require the power supply depending on its type.

Be cautious.

Chapter ３.

Operation and Setup Tools and HDD Install

NVR Model can be controlled easily by using the front panel, remote controller and mouse.

３-１

Remote Controller

POWER

Turn the system power

ON or OFF.

MODE

FULL 1CH Mode

QUAD 4CH Mode

9 SPLIT 9CH Mode

16 SPLIT 16CH Mode

SEQ. Sequence Mode ON/OFF

B) System Operation and Setup Button

MENU Data, Schedule, System Set up

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

Sin comentarios

Signal NVR 2708 Especificaciones Pagina 10