Signal SS650 Manual de instrucciones Pagina 1

PLITSTR247 REV. D 7/28/05 A Division of Star Headlight & Lantern Co., Inc. INSTALLATION AND OPERATING INSTRUCTION MANUAL SS650 SIREN

-8- VEHICLEHORN11 - No ConnectionHornSwitch/Relay12 - Brown (#16 AWG)+12 VDCPositive Switching AUX Horn Jumper Selected6 - White w/Orange Stripe (LC

-9- OPERATION GENERAL This unit is designed for easy operation under the stress associated with high-speed pursuit. Most siren functio

-10- SIREN OUTPUT: Selector Switch Position: Speaker Output Pressing Manual Pushbutton Wail Wail Yelp Yelp Yelp Phaser (or Two-Tone) (Remains Ye

-11- TROUBLESHOOTING Symptom Possible Cause Check No power Power source not turned on Connector loose Amplifier 15A fuse blown Loose connect

-12- SPECIFICATIONS Input Voltage 10 - 16 VDC (negative ground) Input Current 8 Amps @ 13.6 VDC (100W speaker) Standby Current Less than 20 mA O

-13- LIMITED WARRANTY Signal Vehicle Products warrants this new product to be free from defects in material and workmanship, under normal use and se

-14- www.star1889.com

This page intentionally left blank

-1- INSTALLATION INFORMATION TABLE OF CONTENTS GENERAL DESCRIPTION 2 SAFETY PRECAUTIONS 2 INSTALLATION 2-8 UNPACKING 3 INSTALLER-SELE

-2- GENERAL DESCRIPTION The SS650 and LCS652 Siren Amplifiers are designed for single 100W speaker use. Each comes standard with the ampl

-3- GENERAL INSTALLATION Proper installation of the unit is essential for years of safe, reliable operation. Please read all instructions before in

-4- AMPLIFIER COVER REMOVAL If you need to change any of the three options listed above you will need to access the inside of the siren. Remove th

-5- MOUNTING AMPLIFIER The SS650 and LCS652 sirens may be mounted above the dash, below the dash, on a tunnel, or in a rack with the mounting u-bra

-6- AMPLIFIER All of the necessary electrical connections to the amplifier are made through a connector located on the back of the amplifier case.

-7- Wiring Connections: Black: (Pin 2) Ground - Connect the black wire to the negative of the battery, or to a good chassis ground. Be sure to