-6-
Optional Tone Programming
The SS650 and LCS652 can be programmed to produce 6 different tones/sounds by
activating its various functions:
Function Default Tone
Wail Wail
Yelp Yelp
Yelp Step Up Phaser
Manual Ramp Up
Horn Air Horn
Auxiliary Air Horn
Each of these functions can be programmed for a different tone if desired. If you would like
to change the default sounds for any of the six functions, follow the instructions below.
1. Power the unit up.
2. Activate the function you wish to change.
• For Wail and Yelp functions, flip the Wail/Yelp switch into the
corresponding position.
• For the Manual, Horn, or AUX functions, press and hold the Manual
button, Horn button, or steering wheel horn, respectively.
• For the Yelp Step Up function, flip the Wail/Yelp switch into the Yelp
position, then press and release the Manual button.
The tone that is currently programmed for that function will sound.
3. Press and release the Program button on the rear of
the siren to cycle through the list of optional tones.
Review the chart below for a list of optional tones.
4. De-activate the function to save the new tone.
Program Button
1
WAIL (Wail default) §, *, †
2
YELP (Yelp default) §, *
3
PHASER (Yelp Step Up default)
4
TWO TONE
5
MECHANICAL WAIL
(FIRE ENGINE)
†
7
HOOT
8
RAPID HOOT
9
AIR HORN & YELP
10
GHOST
11
RAPID GHOST
12
SINGLE AIR HORN
13
SINGLE QUICK
14
DOUBLE POST POP AIR HORN
15
TWO TONE AIR HORN
16
STANDARD AIR HORN
Tones For Wail and Yelp Buttons
and Yelp Step-Up Function
§ = SAE approved
* = California Title 13 approved
† = See below
6
MAX YELP §, *
Tones For Manual Button and AUX Wire
1
STANDARD AIR HORN (AUX default)
2
LOW FREQUENCY AIR HORN
3
RAPID AIR HORN
4
AIR HORN II
5
DOUBLE POST POP AIR HORN
6
SINGLE AIR HORN
7
SINGLE QUICK AIR HORN
8
TWO TONE AIR HORN
9 MANUAL (Manual default) *, †
10 MECHANICAL MANUAL
(FIRE ENGINE)
†
Tones for Horn Button
1
STANDARD AIR HORN (default)
2
LOW FREQUENCY AIR HORN
3
RAPID AIR HORN
4
AIR HORN II
5
DOUBLE POST POP AIR HORN
6
SINGLE AIR HORN
7
SINGLE QUICK AIR HORN
8
TWO TONE AIR HORN
►►►►
System Reset
◄◄◄◄
If you would like to reset all of the siren programming
options to their defaults, activate any tone and press the
Program button for six (6) seconds. The LED will flash
once, then twice, then all siren tones will stop.
Wind Down or Hard Stop Option
By default, the Wail and Manual tones indicated by the “†” above will “wind down” when
they are de-activated. If you prefer to have them immediately stop (i.e. hard stop), hold the
Program Button for 3 seconds (until the LED flashes once). This will change them to a hard
stop. Repeat to change back to the wind down option.
(20 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales